My EX90 screen went blank.
Unable to reset the device with below procedure.
1. Unplug the power cable.
2. Replug the power cable.
3. Press and hold the power button immediately when the green LED in the bottom
left corner lights up. Hold until the LED turns off and on again after approximately 10
seconds.
4. Release the power button, and press it twice within 2 seconds.
The Cisco TelePresence EX60/EX90 is now reset to factory defaults.
Is there a way, i can console in to EX devices. I yes, will i be able to execute this...
xCommand systemunit FactoryReset Confirm: Yes
Regards // Rameez