Failed: 485 Ambiguous / Device type mismatch

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-07-2016 08:25 PM - edited 03-18-2019 06:27 AM
Hi Cisco Team.
Pls, help to check issue, when register Cisco DX80 in CUCM
Status: Failed: 485 Ambiguous / Device type mismatch
Thanks team.
- Labels:
-
Room Endpoints

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-10-2016 11:16 AM
Hi,
What device type are you using in CUCM?
With CE software on the DX series, it requires a device type of "Cisco Telepresence DX80"
and not the "Cisco DX80" device Type.
-Jonathan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-10-2016 08:31 PM
I using Cisco Telepresence DX80. it registered in CUCM. Thanks you for support.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-10-2016 12:14 PM
If you haven't already, you should install the proper device pack on your CUCM to add the new "Cisco TelePresence DX" device types that are used when running CE software on the DX70/80, these device types are different than the "Cisco DX" device types that run Android software. If you haven't done so already, suggest you take a look at Convert between CE software and Android-based software.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-10-2016 08:30 PM
Thanks so much, Cisco TelePresence DX80 registered on CUCM.
