Feedback option key on Edge95

[Nattapong Rojnakarin]

I have a question what is the feedback option key on Edge95.Anybody know it please help me

thankyou

[mubakhta]

Hi Nattapong

There is no feedback option key on the Edge. These are the various types of keys for MXP :

• IP Bandwidth Key
• ISDN Bandwidth Key
• Release Key
• Option Keys (Like Dual Display, etc)

Could you please let us know where did you find this name "Feedback Option Key".

Regards,

Mubashshir Akhtar

[Justin Ferello]

Nattapong,

The 'Feedback' key is only required for the proper functionality of the 'Synch' product.  It allows the codec to output information not normally available outside of integrator codecs.

Thanks,

Justin

[Martin Koch]

Never heard about it +5 :-)

[Tomonori Taniguchi]

In general, Edge MXP is not design for integration therefore “xfeedback” is not available on API like T3000MXP/T6000MXP support.

For specific special integration, by adding feedback option key (xConfiguration OptionKey Special: < 0="">), Edge MXP coded to support additional feedback feature to integrate with external device, like solution Sync/Whiteboard.

[Nattapong Rojnakarin]

Dear all

Thank you so much I know all option like you but I bought cisco telepresence synch intregate with smart board from tac told me " You have feed back option key already" that make me confuse because I know Edge 95 is full option not another option anyway thank you for help

[Tomonori Taniguchi]

Just clarify the option key for Edge MXP.

MXP only take “one” 16 digits key for each option configuration (feature, bandwidth, and special).

Feature (xConfiguration OptionKey Features): either “no option”, “NPP only” or “NPP + Multisite”.

Bandwidth (xConfiguration OptionKey Bandwidth): either “IP only”, “IP + ISDN” or higher bandwidth range of “IP + ISDN”.

Special feature (xConfiguration OptionKey Special): feedback for integration product