FXS PLAR CONFIGURATION HELP.

[arellanolouie]

The design is like a Private phone line between two site over VOIP network. Im using CCME 7 on both routers.

Private Phone connects to fxs on router and thesame setup on the other site. attached the design diagram and config.

[Daniele Giordano]

Try to use "connection plar opx" under voice-port on both side. In this way, when the phone become off hook calls automatically the remote extension.

Regards.

[arellanolouie]

hi Daniele,

is this correct Dan,

voice-port 0/3/0

connection plar opx 1111

caller-id enable

it gives an error code 21.

[Daniele Giordano]

Do you have configured connection plar opx in both sites? Do you have removed connection trunk?

Can you add the output of "debug voice ccapi inout"?

Regards.