I've set up a fairly simple CCM system with a GK h225 trunk to a local GK. The GK has several local zones only. There are 2 netmeeting PCs registered via the GK. There are 2 VTA devices on CCM.
I can make calls to/from all the devices without problem.
When I make a call in the following scenarios, the B/W on the GK shown using "show gatekeeper call" is as follows:
VTA to NetM = 128k
NetM to VTA = 0k
NetM to NetM = 0k
Voice/video works in all scenarios. My questions are:
Why do some show up as 0k?
I was expecting to see higher than 128k because of the Video element. Why does the B/W not include the video?
All audio calls are G711.
Any ideas? Many thanks, Mark.