Solved: Lost camera control on touch 10 after installing CAB-HDMI-PHD12XS TC 8.3

DbD Systems · ‎12-22-2017

Hi,

After swapping the normal hybrid camera cable on P40 with CAB-HDMI-PHD12XS on both ends, we lost the camera control on touch 10. Picture itself on camera is showing, only controlling of it is missing.

Is there a limitation on Cat cable length or do i need to get CAB-PHD4XS2-SPLIT to the other end?

Also what Cat cable can i use, does it has to be shielded?

We get tho error message "Camera not detected"

We have SX20 codec in use.

-DbD-

Wayne DeNardi · ‎12-26-2017

If you're using the cable that came with the SX20 (custom connector on one end, and a male RJ and make HDMI on the other), then you can just extend it with a standard straight through Cat6 cable and a RJ cable joiner.

If you're using a pair of the 4XS2-SPLIT cables, then you need to cross pins 3 and 6.

Wayne

Please remember to mark helpful responses and to set your question as answered if appropriate.

View solution in original post

Wayne DeNardi · ‎12-26-2017

If you're using the cable that came with the SX20 (custom connector on one end, and a male RJ and make HDMI on the other), then you can just extend it with a standard straight through Cat6 cable and a RJ cable joiner.

If you're using a pair of the 4XS2-SPLIT cables, then you need to cross pins 3 and 6.

Wayne

Please remember to mark helpful responses and to set your question as answered if appropriate.