Hi guys,
I'm stack on a issue with movi with VCS StarterPack X6.1, My MOVI is not working from outside I'm getting the error unable to connect to server, after checking documentation I found the following to be checked but it's seems everything is done from my side.
Login failed – Unable to connect to server
- The term “server” refers to the provisioning server before the Movi is provisioned, and the Cisco VCS after Movi is provisioned.
- Check that the Internal VCS and External VCS names on the Movi Advanced dialog are resolvable by the Movi PC and resolve to the Cisco VCS Expressway Starter Pack address, for example by attempting to ping the DNS names. (These are the addresses Movi uses when requesting to be provisioned.)
- Check that the Cluster name (FQDN for provisioning) on the VCS configuration > Clustering page of Cisco VCS is resolvable by the Movi PC and resolves to the Cisco VCS Expressway Starter Pack address, for example by attempting to ping the DNS name.
- Check that TCP mode and TLS mode are both set to On. (Check this on the VCS configuration > Protocols > SIP > Configuration page.)
- Make sure the Cisco VCS is configured to listen on the ports Movi is trying to access, by default TCP port = 5060 and TLS port = 5061. (Check this on the VCS configuration > Protocols > SIP > Configuration page.)
I have the VCS behind ASA but I'm opening full access (IP) to the server, and I'm doing NAT
Any other advises?
Thanks a lot
Naoufal
