Multiple Screen Endpoints in CUVC

[jmunoz19]

We have a CUVC 5230 running 7.2.0.0.1.  Single screen/codec units work great with it.  However, I am unable to get multiple screen endpoints to connect more than one codec to the CUVC.  I know that with a Codian/Tandberg TelePresence Server, I need to add a "Grouped Endpoint" with the IP addresses of the codecs in order to make this work.

How can I get multiple codec endpoints on a CUVC?  It's not obvious in the configuration.  Perhaps I'm missing a license?

Thanks!

[gogasca]

which triple screen endpoints?

Cisco CTS you need CTMS

for non-CTS I dont think is possible with that version

[jmunoz19]

Yes, I'm referring to multiscreen Polycom units.  I can only get one codec on multiscreen Polycoms to connect to the CUVC.  I know that in the Codian TelePresence Server you configure all the IPs of the endpoint in order to make it work.  However, I don't see how to configure this in the CUVC.  Is this possible?

Thanks!

[ITBUILDERS_2]

Hi JMUNOZ,

Reffering to your last post, I wish you can give me a insight for a probable hickup that I'm having.

I'm trying to Connect a THREE SCREEN POLYCOM ATX 300 to A Cordian 4500 MCU. Would all three screens be displayed to other conference participents?

thanks

DW

[jmunoz19]

Only the primary codec of the ATX 300 will show up on the Codian 4500 MCU.  Codian/Cisco wants you to purchase a TelePresence Server (along with a "Grouped Endpoints" license) for third party multiple screen endpoints.  You add the ATX as a "Grouped Endpoint" and call all the codecs into the TelePresence Server.  The TelePresence Server will then recognize that the three codecs are actually a single endpoint and will group them accordingly.

The Polycom RMX bridge will also group the endpoints for you.

Thanks, Jeff