Solved: MX700 Camera error

NEUNG HWI KIM · ‎07-05-2017

Hi,

I have deployed MX700 but there comes an error on the screen.

The error says there is a camera problem and the video has been stop.

I have re-installed all of the cables, made a factory-reset, but this issue isn't solved yet.

I will attach the capture file and please check if this is an error.

Wayne DeNardi · ‎07-05-2017

If you've done all that, and still get the message, then it is likely faulty. I'd suggest you log a call with the TAC to get a replacement.

Wayne

Please remember to mark helpful responses and to set your question as answered if appropriate.

Wayne DeNardi · ‎07-05-2017

If you've done all that, and still get the message, then it is likely faulty. I'd suggest you log a call with the TAC to get a replacement.

Wayne

Please remember to mark helpful responses and to set your question as answered if appropriate.

NEUNG HWI KIM · ‎07-05-2017

Hi Wayne,

Thanks for your reply.

I was expecting if there was a same problem or bug report about it.

I'll open the TAC Case to try to solve this issue.

Thank you.

m183678263811 · ‎07-03-2018

Hi
I have the same problem and how did you solve it . Can you share it , thank you.