neighbor VCSE's

[MCUManager]

All,

I am novice MCU operator. I received a request to neighbor my VCSE. My problem is that I do not know where to begin or how to do it. Where can I get instructions or directions on doing this?

R,

Greg Smith

[Martin Koch]

Did you check out the VCS admin and deployment guides?

http://www.cisco.com/en/US/products/ps11337/prod_maintenance_guides_list.html

http://www.cisco.com/en/US/products/ps11337/products_installation_and_configuration_guides_list.html

Like the X7.2 admin guide:

http://www.cisco.com/en/US/docs/telepresence/infrastructure/vcs/admin_guide/Cisco_VCS_Administrator_Guide_X7-2.pdf

and the basic vcs-c/e deployment guide:

http://www.cisco.com/en/US/docs/telepresence/infrastructure/vcs/config_guide/Cisco_VCS_Basic_Configuration_Control_with_Expressway_Deployment_Guide_X7-2.pdf

could be a good start for basic understanding.

Is this for some intra company setup or some external call flow?

In general for business to business setup I would prefer routing via the DNS zone, so a neighboring to a specific

external VCS is not necessary.

Why dont you start talking to the remote site which you should neighbor up with to give you some more information

why and how. If you trust them and they are knowledgable that might be the easiest way to go :-)