02-06-2014 05:13 PM - edited 03-18-2019 02:33 AM
I have a C20 running 6.0.1 and cannot access the web interface. I have checked all of the IP settings using the remote and have come up with nothing out of the ordinary. I am able to ping the C20 and get the cisco logo in the internet explorer tab, but can't connect. Has anyone experianced this before?
Solved! Go to Solution.
02-07-2014 08:37 AM
Hi Justin,
In case you can do telnet/ssh to the codec and just the web interface is not coming up,kindly check the HTTP and HTTPS modes and turn them on as per requirement :-
xConfiguration NetworkServices HTTP Mode: On
xConfiguration NetworkServices HTTPS Mode: On
Also, is it registered on any CUCM?
02-06-2014 05:29 PM
I don't have a C20, but have seen similar issues with some other codecs, when using either a really old, or a really new version of IE.
If using an old version, upgrade to a more recent version, and if using the more recent versions, try turning compatibility mode on for that web page.
Alternately, a different browser (Firefox usually works well from my experience) may help.
Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
Please remember to mark helpful responses and to set your question as answered if appropriate.
02-07-2014 08:20 AM
Thanks Wayne. I tried using compatibility mode and fierfox without any luck. i also took the network out of the picture and used a crossover cable directly between my laptop and the C20.
02-09-2014 03:45 PM
I assume you've tried the obvious - turning it off and then on again...
Are you able to get to the device via telnet or ssh?
If you can get to it via ssh, you can try to do a software upgrade/reinstall via WinSCP (see this document if you're unsure how) which may help.
Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
Please remember to mark helpful responses and to set your question as answered if appropriate.
02-07-2014 08:37 AM
Hi Justin,
In case you can do telnet/ssh to the codec and just the web interface is not coming up,kindly check the HTTP and HTTPS modes and turn them on as per requirement :-
xConfiguration NetworkServices HTTP Mode: On
xConfiguration NetworkServices HTTPS Mode: On
Also, is it registered on any CUCM?
02-11-2014 09:03 AM
That was it. Turned on HTTP and HTTPS. Thank you.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide