09-14-2014 03:56 AM - last edited on 03-25-2019 09:12 PM by ciscomoderator
A/ Description:
In our system environment, we have 03 FTTH internet lines
( internet load balancing in one router 2921
This router have intergrated card EHWVIC-4ESG inside this router)
G0/0 ppoe: line 1
G0/1 ppoe: line 2
G0/2 ppoe: line 3
EHWVIC-4ESG connected to LAN
B/ Main purpose we want to do
Now we want to define in this router as below:
step 1- define NAT rule for only webmail service running on line 01.
step 2- define the left 02 internet lines to run internet service.
C/ Current Situation which we face now:
After we configured, above step 1 ( in B section) didn't run properly such as:
from outside, we access this webmail service(http://webmail@abc.com), after server authourize and reply this session, we have 02 scenarios:
1/ the reply to users' session on sometimes right public IP we want, so user can access the webmail server => OK
2/ Sometimes, the reply to users' session on the left 02 lines, so User can not access the webmail server => not OK
note: please see more details in below attached configuration file
we hope to receive your feedback asap.
09-14-2014 05:58 PM
I think you may have posted this in the wrong section of the forums (TelePresence) - perhaps you should move your question to a section of the forums that is more appropriate, ie WAN, Routing and Switching where there are likely more experts in the area you are querying.
Wayne
--
Please remember to rate responses and to mark your question as answered if appropriate.
Please remember to mark helpful responses and to set your question as answered if appropriate.
09-14-2014 07:19 PM
thank you
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide