11-02-2017 06:48 AM - edited 03-18-2019 01:35 PM
How do you remove the Spark Room end point from maintenance mode ?
11-02-2017 04:23 PM
The quickest way will be to re-load the CE software on to the endpoint via the web interface.
Please remember to mark helpful responses and to set your question as answered if appropriate.
11-03-2017 02:27 AM
Hello Wayne,
I did a Software Recovery Swap and I reloaded software ce9.1.4 but on both occasions the unit remained in maintenance mode after the reboot.
11-05-2017 07:03 PM
If you've re-loaded the software and done a factory reset and the device is still failing to boot normally and keeps coming up in Maintenance Mode, then I'd suggest that you log a call with the TAC as the unit may need to be RMA'd.
Please remember to mark helpful responses and to set your question as answered if appropriate.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide