Support required to set up conference

[vinodr]

HI All,

We are using Telepresence server (vir.2.3) with 2 media 820 ( vir.4.3),Conductor , VCSC.

In our environment we are having Polycom VC endpoints of VSX 7000 which will use Cisco VC infrastructure at central sites.

Deployed Equipment details is mentioned below-

1. MSE 8000 with 2 nos. of Media blade(820)
2. VCS-C
3. TP Conductor

Endpoint tested mentioned below-

       Polycom HDX 7000 – registered as a SIP endpoint in VCS-C

       Polycom VSX7000- registered as H.323 device in VCS-C, we have made interworking status as “ON” to make this endpoint participate in the conference.

 Support Required

We require your support for below mentioned points-

1. Registration of Polycom VSX 7000 as a SIP device in VCS-C
2. Clustering of two 820 media blades.
3. Multiparty layout management during the multiparty call through Conductor or TP Server.

[Patrick Sparkman]

You need to configure the SIP settings on the Polycom VSX 7000, refer to the Configuring IP Settings chapter in the Administrator's Guide for the VSX Series.

Use the Supervisor MSE 8050 to cluster MSE 8000 blades, the option is located under Clustering > Configuration, refer to the Clustering chapter in the Supervisor MSE 8050 Help Guide for 2.3(1.46).

The TelePresence Server layouts are determined by the conference template within Conductor and are applied when the conference is created.  If using Cisco endpoints paired with a TelePresence Touch, you can use ActiveControl to change the layout that is displayed to that particular endpoint, refer to the ActiveControl in Optimized Conferencing for CUCM and Cisco VCS (Release 3.0) for more information.