02-12-2016 08:03 AM - edited 03-18-2019 05:34 AM
Hi,
I want to know how can i configure an SX20 with multisite license with CUCM to create video conference between 3 endpoint (2*SX10 and one SX20)
without using (TS and conductor)
THANKS.
Solved! Go to Solution.
02-12-2016 08:37 AM
On the device settings page for the SX20 in CUCM, under Multipoint Mode choose "Use Endpoint", this will allow the endpoint to use it's built-in MultiSite feature. Refer to the following guides for reference depending on if the endpoint is running TC or CE software:
TelePresence Endpoints Deployment Guide for CUCM 11.0.1 (CE8.0)
TelePresence Administering TC Endpoints on CUCM 10.5.1 (TC7.2)
02-12-2016 08:37 AM
On the device settings page for the SX20 in CUCM, under Multipoint Mode choose "Use Endpoint", this will allow the endpoint to use it's built-in MultiSite feature. Refer to the following guides for reference depending on if the endpoint is running TC or CE software:
TelePresence Endpoints Deployment Guide for CUCM 11.0.1 (CE8.0)
TelePresence Administering TC Endpoints on CUCM 10.5.1 (TC7.2)
02-12-2016 01:54 PM
I have SX20 with Software TC 7.3.4 and CUCM version 11.0.1
02-12-2016 02:16 PM
The configuration setting within CUCM would still be the same, no matter the endpoint or CUCM software version. The guides I linked in my earlier post are the most recent for both endpoint and CUCM versions.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide