T1 PRI error

[andre_daley]

Hello everyone,

I am integrating a router with a Nortel PBX . When call are being make the user gets a busy signal. When I did the debug I realize that the router is getting a release message from the PBX. I am not sure can be done to resolve this. I know that it something to do with the D channel.

Thanks

[ciscosri18]

Hi,

Itz good to see your Cisco Router configuration, by the way you can check your Nortel Side configuration also.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a008011888c.shtml

Regards,

Sriharshaa Prabhakar