Telepresence Traffic Consumption

[shincanada]

Hello,

I am looking for an updated version of this document 

http://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Video/TP_InterOp_v2.html#wp1244568

If this document is still current, are these bandwidth requirements both Tx and Rx, or just Tx?

Thank you

Jared

[Venkatesh Perumal]

http://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Video/TP_InterOp_v2.pdf

[shincanada]

That's almsot the exact same document from 2010. I am looking for one with the current collaboration endpoints and blades in use.

[shincanada]

Any other suggestions? Looking for a bandwidth break down to help us map the change from SD to HD.

[Patrick Sparkman]

What endpoints do you have deployed?

[shincanada]

Hi Patrick,

We have a variety, but the majority are SX and C series end points. There is a handful of MXP series out there but we are phasing them out. I see they both have a minimum bandwidth of 768kps, but I am curious if that is per screen, per endpoint, and in both Tx and Rx or only Tx/Rx if that makes sense.

[Patrick Sparkman · Accepted solution]

Take a look at the "Optimal definition profiles" section of the SX80 Admin Guide on pg 143. The bandwidth values listed is the minimum required for a HD and Full HD call. Transmit and receive bandwidth for the main video and content channels will share that bandwidth. 

Note when looking at the chart in the admin guide, the SX80, it has the capability to make H265 calls, all other endowing like C and SX endpoints will make H264 calls. 

[shincanada]

Thanks Patrick, this is what I was looking for.