Hi Friends,
I am facing an issue 'no signal' on display screen when connect to SX10 codec HDMI output port
I tried the same HDMI cable to connect my laptop and its works fine and displays laptop screen on tv display.
Codec software version: ce 9.13.1 98dd07c4099 (upgraded few month before from ce 8.2.2)
On configuration part:
Video output connector1
CEC mode : On
OverscanLevel: Medium
Resolution: Auto
RGBQuantizationRange: Full
1)Is there any cases where codec video hdmi output become faulty because of hdmi input port on display like voltage issue on ports?
2)Without proper grounding on tv power supply will leads to codec output port faulty?
3) Is it mandatory to use Cisco hdmi cable mentioned in sx10 datasheet?
Anybody have any informations regards with these issue and my doubts, please share and support.