Using MX200 and MX700 as a standalaone

[peternnaji]

Hi Guys, 

I have 2qty MX200 and 1qty MX700 as a standalone, without any CUCM or MCU. But these devices have the multisite features.

I intend to use them for three locations fpr video confrencing.

Is this possible? If so, how do I go about it?

Regards, 

Peter.

[Manish Gogna]

Hi Peter,

Multisite key would allow you to have a video conference ( 1+3 ) without the need for any MCU.

Manish

[peternnaji]

Hello Manish, 

Thank you for your response.

I am aware that I can do (1+3) without any MCU. I just want to be sure that I can use the devices as a standalone and how to go about the configurations/proceedures.

Regards

[Oleksandr Yurchenko · Accepted solution]

Hello Peter,

There are a lot of discussion in this forum for standalone endpoints , you could do a search and see what others have done or recommend.

MX have same configuration as SX, EX, C - series endpoints.

br Oleksandr

[peternnaji]

Thank you Oleksandr, 

I got a good response here: 

https://supportforums.cisco.com/discussion/12158971/mx300-endpoint-standalone

Regards,