07-23-2014 01:47 PM - edited 03-18-2019 03:13 AM
Hello Community,
can you please explain me, how I put a VCSESTRTPACK to Internet? Just put the public IP-Address to the Interface configuration? I just have one public IP, so I have to NAT? Or is it possible to make it work. I want to register devices from outside over the Internet. Some endpoints are behind NAT.
How is the routing configuration and the network deployment?
I will put the VCSESTARTPACK for register server from external endpoints over the internet.
And for internal service use a MCU and TMS. So I nedd communication from intern and extern to my VCSESTARTPACK. Is it possible to connect a internal VCSC to it to increase registrations?
Thank you
Solved! Go to Solution.
07-23-2014 03:16 PM
Duplicate posts.
Go here: https://supportforums.cisco.com/discussion/12263321/vcs-starter-pack-express-update-vcse
07-23-2014 03:16 PM
Duplicate posts.
Go here: https://supportforums.cisco.com/discussion/12263321/vcs-starter-pack-express-update-vcse
07-24-2014 05:46 AM
Before we want to update the STARTPACK to a VCSE, we want to put it on the public IP. How does it works? Just configure the Interface with a static public IP?
So we want to build up the system without DUALNIC first. I can put it on the DMZ or outside. If I configure a public IP on the VCS I don´t need the DUAL feature, right?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide