09-05-2006 04:35 PM - edited 03-17-2019 08:47 PM
I have a Tandberg MXP3000 configured as an H.323 client in CallManager 4.0.2a, I am running into some issues when calling between Cisco VTA and Tandberg MXP3000.
When I initiate a call from the Tandberg MXP3000 to a Cisco VTA I can only see the extension number display but the Cisco VTA can see both the extension and the name display. And on incoming call initiated from the Cisco VTA, the Tandberg MXP3000 can only display the IP address of the CallManager where the calling phone is registered.
Can someone helps explain if this is a normal behavior between a SCCP and an H.323 client ?
And another issue is the Tandberg MXP3000 looses its remote video stream after it was put on hold and resume.
Thank you in advance !!
Danny
09-12-2006 07:54 AM
10-17-2006 05:26 AM
What version of software is the 300MXP running?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide