Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all ... Hope everyone is well !!I am trying to bring up BGP between my C8500L and my ISP. Both my C8500L and ISP are connected to a Cisco C9300X. I am able to establish BGP with ISP however it only stays up for about 20-25 minutes. The issue can b...
Hello all ... Hope everyone is doing well !!!I have a couple questions around the Cisco C9300X-24Y-E interfaces. My first time working on this specific model so I am a bit unfamiliar with the interfaces in the running-config. In the running-config I ...
Hi all, hope everyone is doing well !!!I've got a topology below and mutual route redistribution is needed on the N9504 but I do not want EIGRP routes coming from the Cisco 4431 get redistributed into BGP. what's the best method to accomplish this ? ...
Hi all, hope everyone is doing well !!!I just bought a pair of N9504 with dual SUP to replace my N7K. I am working on bringing the N9504s online as we speak and just to find out that non-disruptive ISSU is not supported on N9K modular chassis. I am s...
Hello all,I have a stack of C9200-24T with NM-4X modules. I have a couple 1G SFPs installed and in the running-config I can see G1/1/1 - G1/1/4 and T1/1/1 - T1/1/4 so I figure I could use G1/1/1-G1/1/4 since I have 1G SFPs. But then I run "show int s...
Thanks David and Ruben for your inputs !!! I very much appreciate it !!!My end goal is to redistribute all EIGRP routes from the N7706 and only certain routes from Cisco 4431 MPLS router. I think I can use route-map / prefix-list for this. As for BGP...
You are right Balaji ... it looked that the issue is with my fabric module. I am using N9K-C9504-FM-E which Non-disruptive ISSU is not supported per the link you shared. Would the N9K-C9504-FM-G support non-disruptive ISSU ? Thanks Balaji !!!Danny
Hello MHM, thanks for sharing the link !! appreciate your response !!I checked the link and do not see N9500s in the list.I purchased my N9504 with dual SUP for that reason ... Non-disruptive ISSU.Danny
Hello Balaji ... hope you are doing well !! thank you very much for your response !!I am running NXOS 10.3.4a with the following hardware .. doesn't look like the scenario you mentioned matches mine. See belowN9K-SUP-B+N9K-C9504-FM-EN9K-X97160YC-EXSE...
Hello Flavio, hope you are doing well !!!Thanks Flavio !!! I very much appreciate your help !!! the info you shared is extremely helpful !!Thanks again !!!Danny