12-29-2002 07:47 AM - edited 03-17-2019 07:56 PM
Hi i am running a voip network connected to call terminating service provider
i tried the command
csim start XXXXXXXXX
but i am getting a error message
.CSIM ERR;CSIM_DO_TEST ERROR PEER NOT FOUND
if any one can kindly help.
12-29-2002 09:20 AM
the XXXXX that you're specifying with your csim comand isn't matching a dial-peer. You could do a 'show dialplan num XYZ' first to make sure that it matches a dial-peer. Once it does, then you can do the csim command.
12-29-2002 01:52 PM
THE DESTINATION IP I HAVE IS 202.125.130.75 dialpeer they gave me 4156-011-92-citycode-number
so i configured dial-peer voice 1 voip
destination-pattern +41560092.........
city code is 51 ..
number is 7 digit .......
international code 00
can you kindly tell me where i am wrong
12-29-2002 02:02 PM
thanks for the tip but now i am getting different message
csim err csimdisconnected recvd disc c<2>
csim:loop=1, failed=1
csim:call attemted=1, setup failed=1, tone failed=0
kindly advice
01-07-2003 03:45 PM
Hi,
The csim start will always failed in this case.
The command is used to test basic call setup. Once the
call is setup and connect, it will sent out a tone and expect
to hear that same tone back. Since the line is not loop, the
router did not detect the tone back and thus report it as a failure.
Again, "csim start" hidden command is used to place the call to
troubleshoot call signaling only.
You will need to run further debugs such as "debug voip ccapi inout"
and others to isolate the problem and figure out why the call setup failed.
Thanks,
Chinh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide