06-30-2013 08:55 PM - edited 03-18-2019 01:23 AM
Hi All,
We have a C60 VTC. I know how to change the source for the presentation mode, but I could not find the xCommand for changing the InputSource during a videoconference. There are some commands about changing the far end input source. On the web control of C60, under "Call Control" I can choose the Main Camera or another input that we defined.
I am sure this is a very commonly used feature, but I am new to this field, so please bear with me.
Thanks,
Sinan
06-30-2013 09:10 PM
Hi Sinan,
To change default presentation source you can use this command:
xConfiguration Video DefaultPresentationSource: <1/2/3>
Additionally, you can start a presentation and select the source. Use this command:
xCommand Presentation Start PresentationSource:<1..3>
Regards
Paulo Souza
Please rate replies and mark question as "answered" if applicable.
06-30-2013 09:15 PM
Hi Paulo,
I know the command for starting a presentation and changing the source for presentation source, but what I am looking to get is the source that I select during a VideoConference call. If you are familiar with the web interface of C60, you know that there is a "Call Control" page and on that page two different views: on the left the videoconference source selection, on the right presentation mode source selection. I need to know the command that corresponds to the drop down box selections on the left side.
Thanks,
Sinan
06-30-2013 09:49 PM
Hey Sinan,
Now I got your point, you are talking about the main video source and not presentation source. Try to use this command:
xConfiguration Video MainVideoSource: <1/2/3>
Regards
Paulo Souza
Please rate replies and mark question as "answered" if applicable.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide