C20 TMS Provisioning templates.

[Utair Corporation]

Where do i get them?

Searched through downloads, in TMS section and QuickSet section with no success.

[gubadman · Accepted solution]

C Series endpoints aren't provisioned like EX or MX.

They can be added to TMS in the Navigator section and configured from there instead.

Thanks,
Guy

Sent from Cisco Technical Support iPhone App

[daleritc · Accepted solution]

Correct what Guy says, C Series EPs do not support TMSPE type provisioning. See the TMSPE Deployment doc for what EP systmes are currently supported using TMSPE:

http://www.cisco.com/en/US/docs/telepresence/infrastructure/tmspe/install_guide/Cisco_TMSPE_Deployment_Guide_1-0.pdf

And as Guy says, they can be added to TMS in the Systems > Navigator and then configured using TMS's configuration templates, i.e. Systems > Configuration Templates

[Utair Corporation]

Thanks, guys.

[Paul Woelfel]

Kjetil posted a unsupported solution in another thread to make Provisioning work for C20, which sounds interesting:
https://supportforums.cisco.com/thread/2191224

Sent from Cisco Technical Support iPad App

[daleritc]

Hi Paul,

I've just made a comment on the thread you reference above. What Kjetil says my be possible but until the SX and C-Series folks provide an "official" schematic for these type of EPs so has to provision them with the TMSPE solution, then it won't be "officially" supported by the Cisco support services.

At the end of the day, anything is possible but tread carefully when wading into unsupported solutions

rgds,

Dale