TMS Phonebook: Howto specify preferred protocol

[Juergen Hornung]

Following Scenario, have at TMS Jabber Users configured.

If I setup a phone book with source "Cisco TMS Provisioning Directory" and specify that Jabber users I can see at "View Contacts" H.323 and SIP Protocol for contacting those Jabber users.

How can I specify preferred protocol and how can I enable only one of those protocols?

[Juergen Hornung]

I'm aware of Java High Load errors with Findme, so its not enabled

(It would be good to disabel video address pattern if FM is disabled)

Will do as you suggest and start from scratch...

Thanks guys

[Juergen Hornung]

Hopefully the last question

At Systems -> Provisiong -> Devices

there is a list with all Movi users that are registers once in the past. All devices are registerd with a video address pattern. Is it good to delete them also?

(Don't need any further information of this page).

[daleritc]

I would delete them since you do want to get to a 'scratch' device list and don't particularly want these in the tmspe db 'muddying up' your PB Source since your now importing them to your PB Source.

/Dale

[Juergen Hornung]

Deleted the Devices list - but after signing in again I can see a valid video address pattern.

Whats wrong?

Regards

Juergen

[Magnus Ohm]

Hi jurgen

Its a bug in the vcs that it does not delete the device list (TMS does but the vcs pushes it back, this is also related to the device import bug which causes the high cpu in TMS). It should be fixed in X8.

/Magnus

Sent from Cisco Technical Support iPhone App

[Juergen Hornung]

Should/can I delete the device list at the VCS also?
Or is this not a problem with the video address pattern?

Regards
Juergen


Sent from Cisco Technical Support Android App