Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The PC is connected to the C40 (TC7.1) as source for presentation. Is there a way to automatically display content of this PC when far end side transfers no content?(With other words, screen should display PC content always except far end side transf...
According to Datasheets of MCU and Endpoint both systems are able to do presentations at 1080p at H.264. But all tests resulted at 720p and H.263+.Can you recommend a setting to do 1080p with H.239?ThanksJuergen
After upgrading a c40 to 7.01 I can't access the codec via browser anymore, the webserver seems to be down.Additionally I ran into same error that was reported as "Touchscreen warning message"
And the next question:Is there a guide that describes howto push SIP Outbound configuration to users?We deployed subsequently a VCS cluster and a lot of our users have only one VCS configured.ThanksJuergen
Had this problem in the past too at running Win2008. At the circumstance, that this OS isn't supported with TMS 14.5 anymore I had to upgrade to a newer OS (I choose Win2012R2/64bit) and the problem is gone, TMS runs now smoothly inside VMWare.
But the TMS Bridge Utilization Report does not separate between video and audio only calls.As we use our 4520 bridges for phone conferences also, this would be very helpful if Cisco could update the reports for that szenario also.And to enhance the m...
Hi Martin,its not about "Minimum outgoing bitrate" - its about Content mode, this must be set to "Passthrough".After that SX20 sends H.239 at FullHD/H.264/30fps to MCU.It seems that the MCU45xx series is unable to support FullHD in Hybird or Transcod...
It seems that the problem occurs if the system has installed a certificate and is running in https mode only.To fix this login as root, go to /config/sysconfig/ , edit file http and enable "RUN_HTTP=On"StrangeJuergen
