3725 with IOS c3725-is-mz.122-15.ZJ3.bin, after reload the fxo and fxs port no longer work, no dial tone.Here is the output of show voice call summ:
PORT CODEC VAD VTSP STATE VPM STATE
============ ======== === ==================== ======================
1/0/0 - - - S_OPEN_PEND
1/0/1 - - - S_OPEN_PEND
1/1/0 - - - S_OPEN_PEND
1/1/1 - - - S_OPEN_PEND
I noticed they are not onhook, instead S_open-pend
also show voice dsp tell me there are no dsp dected:
DSP DSP DSPWARE CURR BOOT PAK TX/RX
TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT
==== === == ======== ======= ===== ======= === == ========= == ===== ===========
=
----------------------------FLEX VOICE CARD 1 ------------------------------
*DSP VOICE CHANNELS*
DSP DSP DSPWARE CURR BOOT PAK TX/RX
TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABRT PACK COUNT
===== === == ======== ======= ===== ======= === == ========= == ==== ===========
=
*DSP SIGNALING CHANNELS*
DSP DSP DSPWARE CURR BOOT PAK TX/RX
TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABRT PACK COUNT
===== === == ======== ======= ===== ======= === == ========= == ==== ===========
=
Have searched some doc which says the s_open_pend usually happens in groupstart mode, but my fxo is not groudstart:
voice-port 1/0/0
cptone CA
!
voice-port 1/0/1
cptone CA
!
voice-port 1/1/0
echo-cancel coverage 32
cptone CA
timing hookflash-out 50
timing inter-digit 100
!
voice-port 1/1/1
echo-cancel coverage 32
cptone CA
timing hookflash-out 50
timing inter-digit 100
!
And they were working fine until reboot. it's runnig mgcp and they all registered with ccm fine. First two are FXS and the other two are FXO. I think maybe IOS bug. Thanks