06-22-2005 10:35 AM - edited 03-18-2019 04:44 PM
Does anyone know why I can't access the CUE from the CME via command
"service-module service-Engine 3/0 session" ? I just see the router indicating "Trying 172.17.29.1, 2194 ... Open " and stuck right there. We have a Cisco 3845 as a CME and CUE installed in slot 3.
Thanks
06-23-2005 10:30 AM
Do a 'service-mod service-eng 3/0 status' and make sure it's in a steady state. When you do the 'serv serv 3/0 session' command, you can try pressing control-c; it's possible that the last person did something like 'show trace buffer tail' or something that requires a control-c to interrupt. Otherwise, it's possible that something is configured in the line configuration in the router to block this or something.
06-23-2005 12:16 PM
Here is the status of the module:
"
3845-Coppell#service-module service-Engine 3/0 stat
Service Module is Cisco Service-Engine3/0
Service Module supports session via TTY line 194
Service Module is in Steady state
Getting status from the Service Module, please wait..
cisco service engine 1.1
3845-Coppell#service-module service-Engine 3/0 ses
Trying 172.17.29.1, 2194 ... Open
"
I tried to hit control-c but it didn't do any thing. I had to telnet to the router again and clear line 194 to disconnect the tty session to the CUE.
Here is the line config:
"
line 194
no activation-character
no exec
transport preferred none
transport input all
transport output all
"
06-23-2005 12:39 PM
That is very strange. If you can, you might want to just do a 'serv sev 3/0 reload' then a 'serv serv 3/0 session' to get in and watch the bootup sequence. You might want to capture the sequence to see if you get the CLI then. It sounds like the process that runs the CLI is not running, or else there may be a resource issue (low memory or something) on CUE.
07-20-2005 12:56 PM
I experimented the same issue. From the CME I could not access to the CUE through CLI, in spite of I had access to the GUI Administration page of the CUE.
It looks like a BUG of the 12.4 IOS versions, I downloaded to 12.3T and the problem went away. with access to the CUE you can work in the installation of the software, after that if you want can upgrade to 12.4 again.
Christian
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide