Configure Virtual IP address to MeetingPlace Application Server

[Pravin Kondhare]

Dear Team,

I want to enable virtual IP address (e0:0) to configure Application Server Failover. Kindly help me step by step how to assing IP address & ather details to configure the same.

I have gone through below links but no where I am able to find virtual port configuration.

http://docwiki.cisco.com/wiki/Cisco_Unified_MeetingPlace_Release_8.0_--_Using_the_Command-Line_Interface_(CLI)_on_the_Cisco_Unified_MeetingPlace_Application_Server#Table:_Command_Reference:_Application_Commands_for_the_Application_Server

http://docwiki.cisco.com/wiki/Cisco_Unified_MeetingPlace_Release_8.0_--_Configuring_Application_Server_Failover_for_Cisco_Unified_MeetingPlace#Application_Server_Failover

Request you to please help. Thanks..

[Igor Lukic]

Hi Pravin,

I assume you are running a MeetingPlace Release 8.0 deployment.

I also assume that you want to implement failover on two newly installed Application servers. If so, please refer to:

http://docwiki.cisco.com/wiki/Cisco_Unified_MeetingPlace_Release_8.0_--_Configuring_Application_Server_Failover_for_Cisco_Unified_MeetingPlace#Setting_Up_Failover_for_Two_Newly_Installed_Application_Servers

However, if you already have one Application server up and running and you want to add a new one and implement failover, then you should refer to:

http://docwiki.cisco.com/wiki/Cisco_Unified_MeetingPlace_Release_8.0_--_Configuring_Application_Server_Failover_for_Cisco_Unified_MeetingPlace#Setting_Up_Failover_for_One_Existing_Application_Server_and_One_Newly_Installed_Application_Server

Hope this helps! If so, please rate.

Thank you!

Kind regards,

Igor Lukic