Control Lights from Cisco Phone
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-25-2016 11:57 PM - edited 03-19-2019 11:23 AM
We created a service on Cisco IP phone 7975 in order to send a request to a controller to control the lights and the shades in a room. We were able to create the service successfully and the buttons but the request is not being sent (via XML). Can you please tell us the syntax of the request that we should send?
We used the following but it did not work: Notify:http:10.100.100.10:3001::Blind 1606 close
- Labels:
-
UC Applications
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-26-2016 07:28 AM
Anything related to XML programming, APIs, custom development, etc is handled by DevNet, might want to ask over there.
java
if this helps, please rate
