Solved: CUCMBE r6.1(2) integration in redundant configuration with BE6K

dsmith.tig · ‎02-26-2013

If anyone has knowledge of the following please advise. Is it possible to utilize an existing CUCMBE r6.1(2) on MCS7825 platform in a redundant failover configuration with Cisco BE6K..? Cisco BE6K would be primary. Please advise

Thank you,

Doug

Jaime Valencia · ‎02-26-2013

No, the concept of 6K does not exist below CUCM version 8.

Before that, it's a one box, one point of failure solution, and all the redundancy you could get, is SRST. Right now, that is the 5K solution from the BE portfolio

What you're asking for, are for all matters, 2 separate clusters, so, no redundancy whatsoever between them.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

View solution in original post

Jaime Valencia · ‎02-26-2013

No, the concept of 6K does not exist below CUCM version 8.

Before that, it's a one box, one point of failure solution, and all the redundancy you could get, is SRST. Right now, that is the 5K solution from the BE portfolio

What you're asking for, are for all matters, 2 separate clusters, so, no redundancy whatsoever between them.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate