03-10-2015 12:25 AM - edited 03-19-2019 09:18 AM
Hi All,
I am using Cisco 7845 MCS server (CUCM 6.1) and facing dbreplication issue.
admin:utils dbreplication status
****************************************************************************************************
This command reads and writes database information from all machines and will take quite some time...please be patient.
****************************************************************************************************
-------------------- utils dbreplication status --------------------
Error returned -1 at 1321
Error returned -1 at 802
command failed -- General Error (-1) (-1)
Output is in file cm/trace/dbl/sdi/ReplicationStatus.124300.out
server details:
Publisher
TFTP
sub1
sub2
Remote location server:
bckup sub 1
bckup sub 2
i am able to take web console of server at remote location as we as all others.
admin:show network cluster
10.20.20.11 esic-dc-cucm-pub Publisher
10.20.20.12 esic-dc-cucm-tftp Subscriber
10.20.20.13 esic-dc-cucm-sub01 Subscriber
10.20.20.15 esic-dc-cucm-sub02 Subscriber
10.30.40.10 esic-dc-cucm-bck-sub01 Subscriber
10.30.40.11 esic-dc-cucm-bck-sub02 Subscriber
03-10-2015 02:57 AM
First of all was there any change made on the servers, any extended WAN link outage etc or any reason you think this might have happened?
Run below commands from the publisher server and then all sub servers:
utils dbreplication stop
Once you have verified dbreplication is stopped then from pub server run:
utils dbreplication reset all
It will take some time for the replication to setup, after about 30-40 mins run the following from all servers:
utils dbreplication runtimestate
and post the output here.
-Terry
Please rate all helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide