01-31-2008 07:43 PM - edited 03-18-2019 08:24 PM
We have now connected E1 R2 DID (i.e. H323 gateway in CCM 4.1.3) in to our voice gateway(c2851). However, we get a problem to connect Unity 4.0. We find the call from E1 DID cannot go to Unity when CFwdALL, No answer or busy forward. So, I setup a hunt pilot number (within DID range) and map to voice mail port. I get the busy tone when dial this DID number from outside. I trace the call log in voice gateway and Call View in Unity. It is found that call can be terminated to Unity, but it seems Unity rejects the call. So, I would like to ask whether Unity is compatible with RS232 gateway or not. Below is our configuration.
=========================================
!
voice class h323 1
h225 timeout tcp establish 3
!
!
!
voice translation-rule 1
rule 1 // /5/
!
!
voice translation-profile inbound
translate called 1
!
!
controller E1 0/0/0
framing NO-CRC4
ds0-group 0 timeslots 1-15 type r2-digital r2-compelled ani
cas-custom 0
country philippines
dnis-digits min 1 max 3
!
voice-port 0/0/0:0
translation-profile incoming inbound
!
!
dial-peer voice 402 voip
description CCM-subscriber
preference 1
destination-pattern 5...
voice-class h323 1
session target ipv4:<subscriber ip addr>
dtmf-relay h245-alphanumeric
codec g711ulaw
ip qos dscp cs5 media
no vad
!
dial-peer voice 400 pots
incoming called-number .T
direct-inward-dial
port 0/0/0:0
!
!
dial-peer voice 404 voip
description CCM-publisher
preference 2
destination-pattern 5...
voice-class h323 1
session target ipv4:<publisher ip addr>
dtmf-relay h245-alphanumeric
codec g711ulaw
ip qos dscp cs5 media
no vad
!
=========================================
02-01-2008 08:55 PM
Unity is just another VOIP capable device and is no different to a IP phone. So it should work with E1 R2 or another gateway protocol.
If you can call from the E1 R2 gateway to an IP phone but it fails with Unity, chances are this is a codec issue. Unity may want to use G729, and since your dial peers are only going to advertise G711ulaw, so there may be a codec negotiation problem.
Add the following to your config -
voice class codec 1
codec preference 1 g711ulaw
codec preference 2 g729r8
dial-peer voice 402
no codec g711ulaw
voice-class codec 1
!
dial-peer voice 404
no codec g711ulaw
voice-class codec 1
This will advertise G711 and G729 codec in the H245 capabilities when the call is made.
02-01-2008 11:51 PM
thanks a lot. it works after adding voice-class codec.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide