Hello All,
I am evaluating Cisco's Prime Collaboration Assurance 10.0 application, and for some reason I'm unable to get any Voice Call Quality Reports from a 1040 sensors. I am wondering if anyone can tell if I'm doing anything wrong here.
The sensor is communicating with the Cisco Prime, but reports do not show any data.
Switch#show run | in monitor
monitor session 1 source vlan 10
monitor session 1 destination interface Fa1/0/4
Switch#show monitor session 1
Session 1
---------
Type : Local Session
Source VLANs :
Both : 10
Destination Ports : Fa1/0/4
Encapsulation : Native
Ingress : Disabled
Thank you all.
