cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2165
Views
5
Helpful
2
Replies

UCS C220 M3 doesn't power on automatically when power is restored

zhimzhan
Cisco Employee
Cisco Employee

Hi,

We have 2 UCS C220 M3 server. I had configured the power restoration policy to "power on", but when I try to unplug/plug the power cord, it doesn't power on automatically.  Is there any other config needed or any known issues?

 

The server info and the Power restore policy is attached. Thanks.

1 Accepted Solution

Accepted Solutions

Rob Waller
Level 1
Level 1

Are you looking at the KVM? Does the display show anything at all? Maybe you are not waiting long enough. Also look at this thread: https://community.cisco.com/t5/unified-computing-system/ucs-220m3-auto-startup/td-p/2506436

 

View solution in original post

2 Replies 2

Rob Waller
Level 1
Level 1

Are you looking at the KVM? Does the display show anything at all? Maybe you are not waiting long enough. Also look at this thread: https://community.cisco.com/t5/unified-computing-system/ucs-220m3-auto-startup/td-p/2506436

 

Hi Rob,

 

You are right. During the power shutdown/restore this weekend, the UCS is powered up automatically. From the log, it waits for about 10 minutes to start booting up. When I tested it before, I didn't wait for that long time.

Thanks for your help!