Unity Connection 7.0 eth0 Reporting Half duplex to Syslog

[charles-moore]

Hi All,

Unity Connection 7.0 eth0 Reporting Half duplex to Syslog

Need a little help.

I have a Dev Lab Running Unity connection 7 on VMware ESXI.

The Install is fine and everytjing woks as expected, however I keep getting the following report on syslog the eth0 is set to halfduplex.

I have believe I have changed the Port settings on the Switch interface and on the Unity connection CLI.

But this does not make a blind bit of difference.

Can anyone assist.

Regards

Charles

[Scott Hills]

Hello,

It could be realted to this defect: http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCsy23459

Thanks,

Scott