UPS Client for Communications Manager Ver 5 / 6

[kallan]

Does anyone know whether there is a UPS client for the Communications Manager version 5/6? Customers who were on Version 4 had a UPS client installed on the CUCM to power the system down in the event the UPS power is lost

[Aaron Harrison]

Hi

See this excerpt from the CM6.1 OS Admin Guide:

show ups status

This command shows the current status of the USB-connected APC smart-UPS device and starts the monitoring service if not already started.

This command to give full status is only available on 7835-H2 and 7825-H2 servers.

Command Syntax

show ups status

So yes - this doesn't appear in CM5.x so I think it was added in version 6.

Regards

Aaron

Please rate helpful posts.

[kallan]

Aaron,

Thanks for your quick response. I wasn't aware this command existed.

Regards, Keith.