V-CUBE - running on UCS

[Forcefield]

Hi

Just wanted to see if anyone out there may have tried this or if anyone has any recommendations.

I am looking to see if its possible to run Virtual Cube on the same UCS box that hosts CUCM cluster.

Is this a no-can-do or is there a recommended approach to look at? The idea being of course that the Cube will be our Demarc line to the carrier, I'm just not sure if its a good or bad approach to try.

Thank you

FF

[Deepak Rawat]

Refer below:

http://docwiki.cisco.com/wiki/Unified_Communications_Virtualization_Sizing_Guidelines

Regards

Deepak

[valerie.kan]

I can't say I have done this before, but this link might help you:

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/cube/configuration/cube-book/voi-virtual-cube.html 

It said that virtual CUBE integrated into the Cisco CSR 1000V routers runs on a hypervisor on the Cisco UCS. It works with the ESXi hypervisors supported by Cisco CSR 1000V Series router and is supported on the a few of the UCS configurations.