VOIP call to other country

Mohd Khairul Nizam · ‎08-07-2018

Hi,
we have several connection through WAN to other country, and we setup either ICT or SIP trunk.
but sometime and suddenly I am getting the error message "Not enough bandwidth" from the Cisco desk phone.

we have around 1000+ users in our premises.

Jaime Valencia · ‎08-08-2018

That means you're trying to go over the BW you allocated in your location.

HTH

java

if this helps, please rate

Mohd Khairul Nizam · ‎08-08-2018

we dont have any limitiation and all are default

jonathan.salter · ‎08-20-2018

What location are the devices in?

Please remember to rate useful posts, click on the stars below.

Mohd Khairul Nizam · ‎08-20-2018

everyone is by default, which is Hub_none

jonathan.salter · ‎08-21-2018

Did you verify the Hub_None settings to make sure it has not changed?

Please remember to rate useful posts, click on the stars below.

Mohd Khairul Nizam · ‎08-24-2018

no change at all.
all phone using the same template.
is it because we create

1. additional VOIP to other country

2. additional user

jonathan.salter · ‎08-24-2018

Difficult to troubleshoot at this point without seeing the programming.

Just to be sure you went to the Hub_none location and verified in Advanced Settings there in no limitations correct?

Please remember to rate useful posts, click on the stars below.