cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1083
Views
0
Helpful
1
Replies

After upgrading to 2.2(1d) my VMWare VMs are having LSI errors in the Event Viewer

nick.twaddell
Level 1
Level 1

I upgraded my environment to 2.2(1d) over the past couple weeks.  We have had a few VM's freeze, and one error I have noticed in all the event viewers is

LSI_SAS

Reset to device, \Device\RaidPort0, was issued.

Some have it more than others.  I went back in history and this only occurred in each environment after upgrading to 2.2  Is this a known issue?  I am running ESXi 5.1 Update 2 on my hosts.  each host is a B200 M3

Thanks

1 Reply 1

jboyd0004
Level 1
Level 1


hey Nick

I saw your post at vmware commnuities, and I responded there as well.  I have the same problem and have been working with Cisco TAC, vmware, and EMC on this issue and still don't have an answer.

Did you resolve this issue by upgrading to 2.2(2C)?

Did you have any RDM's attached to your VM's?  I do, and that seems to be where most of my problems are coming from.

Any information would be greatly appreciated.

Joe

Review Cisco Networking products for a $25 gift card