cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
715
Views
5
Helpful
2
Replies

Board Controller startup version not updated 2.2.6e

Walter Dey
VIP Alumni
VIP Alumni

B200-M4, UCS 2.2.6e.

Host Firmware Package 2.2.6e

Autoinstall server 2.2.6e

Board Controller running version 10.0, startup version 5.0

Why is startup version not properly updated ?

see g1 and g2 attachments

2 Replies 2

Qiese Dides
Cisco Employee
Cisco Employee

Hi Walter,

Is your blade using a host firmware policy that has a blade package already set? If so could you make it so there is no pre-defined blade back package or create a new host firmware policy without anything pre-checked.

Than try to activate the board controller through the Installed Firmware Tab. This should clear the error.

Did you just upgrade to 2.2(6e)? I have seen this happen before let me see if there is a known defect.

Regards.

Hi Qiese

Yes it was happening during a upgrade to 2.2.6e, with a HFP set to 2.2.6e.

Disassociating the SP and then manually activating the Board Controller Firmware solved the problem.

I just wonder why this was not working with the HFP ? Is there a know defect ?

Thanks Walter.

Review Cisco Networking for a $25 gift card

Review Cisco Networking for a $25 gift card