C220 can not access the CIMC

[mohammad saeed]

Hi,

I have server C220 and when I want to access the CIMC I got this error message:

Under construction:

the site you are trying to view doesn't currently have a default page. it may be in the process of being upgraded and configured!

what is the issue here?

thanks

[Kirk J]

Greetings.

Can you SSH into the CIMC IP ?

After logging in

Run the following:#scope cimc

/cimc#show firmware

/cimc#reboot

This operation will reboot the Cisco IMC.
Continue?[y|N]Y

Let the CIMC reboot, and see if this state changes.

If you can't log in via SSH, but can PING the CIMC IP, then you may want to try a hard power cycle where you shut down os,, and then remove power from server for 30 sec.  (you might also want to setup a continuous ping test to cimc IP address while server has power removed to confirm you don't have a duplicate IP issue)

You can always try applying an updated HUU ISO (or even the same HUU version) via a bootable USB DVD drive, or bootable USB thumb drive.  For the thumb drive you would need to use a USB bootmaker utility such as 'Rufus' to apply the ISO to the thumbdrive.

Thanks,

Kirk...