08-14-2012 01:43 AM - edited 03-01-2019 10:34 AM
Hi All,
Any one please, guide me how to setup raid on it? I can't see any LSI set up utility during POST (no CTRL+M option available).
Note: CIMC firmware version 1.4(5g)
Thanks
Winai.
10-01-2012 05:57 AM
Paolo,
I don't believe you can modify the block size on the 9216. I'll double check and update this thread if I'm wrong. I believe you can change the block sizing on the 9265 and higher RAID cards.
Robert
10-01-2012 10:40 AM
Paolo,
I did investigate this. You can modify the Stripe size via the WebBIOS utility. I believe this is what you're after.
Regards,
Robert
10-01-2012 06:47 PM
Hi Robert,
Is strip size same as block size? I saw the strip size setting when I pressed Ctrl-H upon boot-up, but the max was only 1mb. I changed the block size via Vsphere Client 4.1 in the storage link.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide