07-24-2011 01:12 PM - edited 03-01-2019 10:00 AM
Does anyone know the link to Cisco documentation that explains how to do this?
07-24-2011 09:49 PM
Martinez,
When create a service profile, you can assign the desired power state of the server in the server assignment section.
You can view the desired power state of a service profile in General > status section.
NOTE There is a typo in the doc where it says that this config is applied before associating the service profile. The action takes place after associating the service profile and not before.
HTH
Padma
07-27-2011 08:48 AM
Padma,
You can do this via the BIOs policy.
I hope that helps,
David Jarzynka
07-27-2011 09:16 AM
David,
Yes, BIOS policy has this option but I believe initial / desired powered state in service profile would supersede this configuration option.
HTH
Padma
07-27-2011 12:33 PM
Padma,
To my knowledge you cannot set the Service Profile power behavior after an AC power loss. You can the the "down" option during profile creation and this will power down the server after association but does does not help you after an AC power loss.
To my knowledge the BIOs policy is the only way.
Thanks,
Dave
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide