Good afternoon.
We have UCS Mini. Connected the following way: cisco switch-- > UCS Mini-- > ESXi. It turned out that on one blade we need to install ESXi with several VLANs on one interface and drive it into the ESXi sweep.
We have set up a service profile, and are configuring a network interface, and we cannot apply multiple VLANs to it. Only native vlan works, i.e. the network on the VM from this vlan only.
From the server that we will transfer these VMs (switch--server--ESXi is connected), VLANs are sent to the virtual swich in ESXI. This results in an intermediate link that does not allow this UCS Manager.
Can you tell me where to dig?
Thank you.
P.s.
1. The neighboring blades have configured the network interface profile for FCM (Hyper-v) - Multiple VLANs on the same interface with one native.
2. there are trunks for UCS and a regular server everywhere on the swich.
3. setting is in the attachment
