How To...Set correct time on UCS for Central Time Zone

[ld_ferguson]

I'm trying to set the time correctly on our UCS.  When going thru the scope instructions for "set timezone" and pick the correct options, the last option is to confirm the time is correct.  However, the time shown at that point is incorrect.

We have the UCS configured for NTP.  All other network devices using the same NTP server are showing correctly.

UCS version 2.1(3c)

Timezone says:  America/Chicago (Central Time), yet is remains 1 hour off.  It was this way last week before daylight savings occurred.

[Walter Dey]

Don't set time with CLI on each FI ! use the NTP and timezone menue in the administration menue of UCSM.

[ld_ferguson]

We have the UCS configured for NTP via the UCSM.  The timezone is set to America/Chicago (Central Time) yet the system time remains incorrect.

[Walter Dey]

Please share the output of following commands

show firmware

show clock

show timezone

connect nxos a

show clock

show ntp status

show ntp statistics

show ntp session status

show ntp source

show ntp peers