I am assuming you are wanting to put the Server back in UCSM mode so the service profile can be re-applied?
If so, make sure all 1 Gb LOM or CIMC connections are removed (if connected), leaving only the pair of 10 or 25GB connections to the FIs (IOMs in this case as it appears you have UCS Mini). Confirm the ports are configured as 'server' still, that will connect to your rack server.
Make sure the Server in question represented in UCSM is in the decomissioned tab. If not go ahead and decomission it (server maint, decomission)
On the KVM of server, go to F8 (CIMC setup), and reset that to factory defaults.
At top Equipment level object, there will be decomissioned tab. For server in question, put check mark in recomission/re-ack tab, and click save at the bottom.
After a few minutes the server should start showing activity in the FSM tab for discovery tasks.
The service profile may/may not auto apply to the server after discovery is complete.
If not, reapply the service profile to it.
If you made different config changes (especially to local storage) then the service profile may have troubles re-applying.
If you know you changed the local raid/disk config while in stand alone mode, you may want to adjust your local disk policy to 'any config' so your existing local disk/raid config does not get over written.
Kirk...
