UCS 6248UP Inoperable

[maxencer]

Hello,
I have a problem on a UCS6248UP on which we have no more support.
Following a power failure, I have the Fabric Interconnect A which has an overall Status: Inoperable. The lights are orange and all the connections to the various equipment are cut.
The Fabric Interconnect A is working fine.

Thanks for the help

[Kirk J]

After pulling power to problem FI for a few minutes, you will want to connect a console cable to the FI so you can see what, if anything, is being written to the console.  Could be corruption with bootflash,, etc.

Kirk...

[maxencer]

the error file is attached. There is a starting problem.

Physical Switch Mgmt0 IPv4 netmask : 255.255.0.0
    Invalid subnet mask.Physical Switch Mgmt0 IPv4 netmask :     Invalid IPv4 form. Should be of form 'X.X.X.X', where each
    letter corresponds to a decimal number between 0 and 255.
  Physical Switch Mgmt0 IPv4 netmask :

Thanks

[maxencer]

And when I start the configuration, I have this error message:

Physical Switch Mgmt0 IPv4 netmask : 255.255.0.0
    Invalid subnet mask.Physical Switch Mgmt0 IPv4 netmask :     Invalid IPv4 form. Should be of form 'X.X.X.X', where each
    letter corresponds to a decimal number between 0 and 255.
  Physical Switch Mgmt0 IPv4 netmask :

 Thanks

[Mark Elsen]

            - FYI : https://bst.cloudapps.cisco.com/bugsearch/bug/CSCus79160

 M.

[maxencer]

An idea ?

[maxencer]

Thanks, but not real solution except contact TAC for assistance recovering. Too bad because I don't have a service contract