01-16-2015 02:13 AM - edited 03-01-2019 11:59 AM
New install 4 blades. 3 of them are working fine KVM Keyboard is ok. On one of them there is no keyboard input translated to the blade when using KVM. Please advice.
01-16-2015 04:12 AM
Does this blade have a CIMC IP address ? and if yes, can you ping it ?
If above is the case
I would try to do a CIMC restart, KVM restart !
01-19-2015 12:34 AM
It does have IP, it is pingable and i have tried:
CIMC restart
KVM reatart
CMOS reset
Blade reseating and re-ack.
01-19-2015 02:04 AM
Please post UCS Version, BIOS, CIMC Version; which I/O adaptor and Version, of the server that fails, and one which is working ?
01-19-2015 02:06 AM
UCS version 2.2.3d. All firmware are the same bundle version. I/O: VIC 1240
01-19-2015 02:10 AM
Strange ! did you see any error message ? syslog ?
open a TAC case !
01-19-2015 02:14 AM
No errors in UCS Manager. In CIMC SEL log however there is an error that says no keyboard detected.
01-19-2015 02:19 AM
Please post the exact error message ! might really be a hardware issue ! you already did all the investigations ! don't waste more time and open a TAC case.
01-19-2015 02:21 AM
I've requested RMA already. Currently I am just digging on to it. Cannot post the error now. I will try later.
10-30-2015 04:40 PM
I am having this exact same issue with B200 M4 blades in a UCS Mini. 4 total blades, 3 are fine but 1 will not respond to keyboard inputs through KVM. The firmware is at 3.0(2d). The built-in macros in the KVM viewer for the function keys do not work as well. Please advise.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide